Puppets and Stuff
Pages: 1 [2]  All   Go Down
Need some ideas for seabirds  (Read 15035 times)
Angel in Tx
« Reply #15 on: September 14, 2011, 05:37:04 am »

I think I see how you did the heads, with the wires running down, but not a clear picture on the white bar and white rings.  So does each wire from each head get a ring, and then the ring is slid onto the bar?  Then when you pull the bar all the puppets work? Also looking at the pic of the mouth, does the bar being pulled open or close the mouths?

As far as the swaying for the birds, I planned to glue the feet down and use a short fabric tube for the legs.  The bodies would not actually be connected to the pvc or whatever I connect them to. But, I'm thinking the bodies might need a dowel, or bar across the back that the puppeteer can hold with their second hand to move them and keep them stable.  I'm going to experiment with it as soon as I can.
Shawn Sorrell
« Reply #16 on: September 14, 2011, 06:17:21 am »

Angel,
I think you are heading in the right direction. What you wrote makes sense to me and give me a picture of what they would be in my head. Smiley
Pages: 1 [2]  All   Go Up

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines

Copyright © 2000-2019 Puppets And Stuff, All Rights Reserved

Privacy Policy - Terms of Service

Page created in 0.095 seconds with 25 queries.

Puppets and Stuff