Puppets and Stuff
Pages: [1]   Go Down
Fleece patterning help?  (Read 626 times)
sjham
No Avatar
« on: March 04, 2017, 04:15:16 pm »

Hi all,

I'm working on a replica of Trekkie monster from Avenue Q and I'm having a lot of trouble trying to create the fabric pattern for his fur. This is what I have so far:
http://imgur.com/a/stqIz
(I think the eyes are too big for Trekkie....what do you think?)


I'm not sure how to pattern the lower jaw of the foam head. I was trying to do the top head and the jaw as separate patterns and then somehow merge them together, but its a mess right now.
I'm also worried about the darts. I think they are very big and could cause
 the fur to go into different directions and make it look messy. I also have no clue about how much fabric to leave for the neck when I have to attach the head to the body :/

Could anyone give me some tips/advice/criticism on how to make a good fleece pattern for this head? Here's some pictures of the foam head if that may help: http://imgur.com/a/Jbs1k \

Thank you!
Shawn Sorrell
« Reply #1 on: March 05, 2017, 06:42:20 am »

Your darts should be fine. Fur hides a multitude of sins. Smiley Should be no issue with cutting the bottom jaw separate, just sew it to the top. Just treat it like a dart. The neck can also be a separate piece, in fact you might want to make the neck part of the body pattern then sew that into the head. Again the fur will hide your seams and you can brush the fur to make a smooth transition.
sjham
No Avatar
« Reply #2 on: March 05, 2017, 07:54:02 pm »

Ahh thank you so much!!  Smiley  Smiley  Saved me a lot of stress and cloth!
Pages: [1]   Go Up

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines

Copyright © 2000-2017 Puppets And Stuff, All Rights Reserved

Privacy Policy - Terms of Service

Page created in 0.118 seconds with 24 queries.

Puppets and Stuff