Puppets and Stuff
Pages: [1]   Go Down
Hare puppet  (Read 115 times)
« on: April 03, 2019, 01:23:09 pm »

I started working on a new hand-puppet for the Eurofurence Pawpet-Show. If you would like to support the show, go to https://www.patreon.com/pawpetshow/overview

This time it will make a rabbit hand-puppet. I modified the 3d-model my bunny costume head base (added a plate in the upper jaw for the puppeteer's hand).


The model was 3d-printed with Amazon Basics PLA.

The lower jaw was connected by making a peg with Plaast (the company making plaast is no longer in business - I'll switch to another manufacturer).

The teeth and tongue were hand-sculpted. I designed a rotatable hinge for the ears that have holes for cable ties - I used those to attach felt ears.

The eyes were made with ping bong balls and my 3d-printed movable eyelids.
They are assembled like this:


The body was made using my usual body pattern with a cheap camping mat and hot glue.

The hand-rods end inside a 3d-printed disc that can rotate inside the hand of the puppet.


It's now ready to put the fur on.
« Last Edit: April 03, 2019, 02:25:41 pm by Tioh »
Pages: [1]   Go Up

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines

Copyright © 2000-2019 Puppets And Stuff, All Rights Reserved

Privacy Policy - Terms of Service

Page created in 0.131 seconds with 24 queries.

Puppets and Stuff