Are there any new methods you use to get your puppeteers heights adjusted to the puppet stage, any new innovations?
Comments
By Shawn on Sep 29, 2020, 7:34 AM
I assume you mean for hand in mouth puppets held above your head. We always used rolling stools. They where low to the ground between  4 to 8 inches high depending on the height of the puppeteer.  Easy to make out of plywood.  Two pieces for top and bottom of stool.  Then cut strips that about the height and join them as an X by cutting slits in the center. Glue and nail the top and bottom pieces to the X  then put wheels on the bottom of them.
By Snail on Jan 21, 2021, 8:52 AM
Yes, for hand and mouth rod puppets. I like the wheels idea, did they work equally well on carpet as hard flooring, if we set up stage in different locations we will have varying floors to work on. Maybe we need to bring our own floor covering with the stage to keep consistent. We tried skate boards that slipped off our knees if we moved, wider base sounds more stable. And if your feet can hang off the back end that is a plus as my feet always hurt when kneeling for long periods. Thanks for the new to me idea.
By Shawn on Jan 22, 2021, 7:25 AM
They worked well on both carpet and hard flooring... well we never really tried it out on shag carpet, but I doubt you are going to run across that unless you are in a private home.

Be aware you can still fall off your stool if you move to fast or try to reach to far.  You need to try and keep your butt centered on the stool.  We normally put a thin layer of foam on top and covered with fabric.
Log In to participate in discussion.
Discussion Started Sep 28, 2020 By
suziedrip8f9
Snail
Member Since: 11/21/09
150 Community Points
2 Badges